918.437.RACE

  • 2012_RCB_Bank_small
  • 3013_Pro-line-racing-tulsa-banner
  • DRR - Tulsa Raceway Park - 145x68
  • GrandPrix_web
  • Holiday_Inn_Owasso_Web_Banner
  • Kennysaccbannerdecal
  • LucasOilDragRacingSeries
  • Medley
  • MidnightDrags2010
  • NHRA_Member_Track-4c
  • OMDE-1288-Tulsa-Raceway-Park-Web-Ads-145x65
  • QuantusLogo
  • RockAuto
  • TCIlogo
  • TaylorMotorsports
  • Trailsend
  • WarrenCATcopy
  • adspace1
  • animal
  • clarion
  • davesrv
  • dieselpp
  • drzad
  • eagle
  • elite
  • fox23side
  • harley
  • hiltongi
  • inductionsolutions2
  • integrity
  • khracing
  • kingoftheTRACK_web
  • mills
  • odmlogo
  • pk
  • racingjunk1
  • sixb
  • stroud
  • sub2014
  • theedge
  • triplecagency
  • ttcu
  • tulsa_truck_works
  • wwclean
  • wyndham hotels and resorts tulsa
  • wyndham hotels and resorts tulsa
  • racing junk classifieds
  • James Hodge Ford
  • Osage Casino
  • racing junk classifieds
  • holiday inn

Welcome, Guest
Username: Password: Remember me
Tech

TOPIC: Fuel?????????

Fuel????????? 2 years 8 months ago #1673

I have a motor i just built and the pistons were 12.7to1 and i had the block milled once and the heads twice i was tring to run 112 octane race gas just put new plugs in and when i went to start it it pined badddd is my fuel not good enogh if not how hard is it to put on alcohol??? :blink:
The administrator has disabled public write access.

Re: Fuel????????? 2 years 8 months ago #1674

Oh I only have enoghe timing in it to keep it runnin just before it dies :sick:
The administrator has disabled public write access.

Re: Fuel????????? 2 years 8 months ago #1682

I may not be the best one to answer your question, but I will take a shot at helping.

1. You say you had the block cut and the heads cut twice. How much P to V clearance do you have? What is your quench area clearance?
2. How much timing is just enough?

We idle a SBC that is a true static 15-1 on 87 octane pump gas. This motor is alcohol injected and we use a primer system to warm and start the car with.

3. Did you verify the pointer is at top dead center with a piston stop when you built the motor?

A little more info might be in order to really help though.

Curtis
The administrator has disabled public write access.

Re: Fuel????????? 2 years 7 months ago #1733

Not sure on p to v I just put it togheter if it hit it hit if it didnt it didnt. about 23-25. just whent turned it till it waz all the way to tdc and did cam timing im runnin a soild cam so it sould have plenty of room.
The administrator has disabled public write access.

Re: Fuel????????? 2 years 7 months ago #1856

it maybe to late, but are you running a spring advanced or a locked out Dist. have you checked the Dist springs, it maybe pulling a lot of advance at start up ??
The administrator has disabled public write access.
Time to create page: 0.125 seconds