Welcome, Guest
Email: Password: Remember me
Race Cars for Sale
  • Page:
  • 1

TOPIC: SOME ASSEMBLY REQUIRED

SOME ASSEMBLY REQUIRED 2 years, 5 months ago #1081

2x3 Backhalf car, 12 point jegs mild steel cage, 4 link/diagonal suspensiom, Tubs, 63 "tubular moly wheelie bars, Qa-1 Coilovers with 125lb springs, 9" ford housing, Nodular center section, 4:86 Pro Gear, 35 Spline spool, 35 spline Moser axels with .625 studs, Strange rear Disk Brakes, Weld Draglight 15x14, Mickey Thompson 16x33 E.T. Drag slicks, Stroud parachute, pack, and pilot. Racecraft Tubular Moly K-member, lower a-arms, caster camber plates, travel limiters. Strange coilover conversion with 200lb springs, on Lakewood struts. Strange front disc brakes, Weld draglight 15x3.5, Goodyear front runners. Moog tie rods, idler arm, and center link. Manual steering box. Afco Alum Scirocco style radiator. 9 gallon fuel cell. Strange master cylinder, Strange residual valves (2), Summit proportioning valve, Biondo line lock, RJ brake and throttle pedals, RJ tubular steering column, Grant steering wheel, Autofab door latches, B&M pro stick shifter, for powerglide,(have gate plates for forward or reverse 3 speed pattern also) Shiftnoid, Dedenbear BM1 delay box, Dedenbear ts1 timer, Autometer guages, (tach,oil press,volts,water temp) Dual Kirkey 17" seats with cloth covers, Auto Rod Controls overhead switch panel with under hood remote, and wiring harness. VFN Fiberglass front end, trunk lid, dash, 6" cowl induction pin on hood, Lexan .187 windshield, side windows, and molded rear window. Ed Quay full body width aluminum spoiler, with struts.

Car needs the floor and firewall put in it, then the body panels, fuel cell, radiator, engine and trans ,dash ,seats, shifter ,chute,and master cylinder all need to be mounted. Plumbing and electrical are also needed.

IF IT IS IN WRITTEN RED, THEN IT IS BRAND NEW

Lost interest, make me a resonable offer, and make it go away.

nine one eight-407-one seven one eight bobalbertyjr(at)yahoo.com

Lots of pic's and history of the car here www.facebook.com/media/set/?set=a.124667...204406175&type=3

WILL NOT SEPARATE, DONT ASK

Re: SOME ASSEMBLY REQUIRED 2 years, 5 months ago #1084

Say it isn't so Bobby!.....Hate to hear this.

Re: SOME ASSEMBLY REQUIRED 2 years, 5 months ago #1134

Larry Tinker wrote:
Say it isn't so Bobby!.....Hate to hear this.


tis true, I dont have the equipment / facilities to finish it, so if i can move it, and buy a roller to put my motor and tranz in, tired of not racing. I'm getting fat sittin on my backside
  • Page:
  • 1
Time to create page: 0.09 seconds